Build a simple JP1 cable

From TIAO's Wiki
Revision as of 12:15, 27 September 2009 by Admin (talk | contribs) (What do you need to spoof the firmware)
Jump to: navigation, search

10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!

USBJP123.small.JPG DG-JP12-02_small.jpg DG-JP1-U02_small.jpg DG-JP1-P02_small.jpg ext_small.jpg pl2303.small.JPG

Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com


What do you need to spoof the firmware

  1. 4 feet of flat ribbon cable
  2. DB25 Housing with Grommet, scews and wire holders
  3. DB25 connector
  4. 1.0k resistor X 2 (necessary for Kameleon and other remotes)
  5. 1N5818 schottky diode works for both desktops and laptops
  6. 6 pin female IDC connector to fit your remote (with strain relief)
  7. 6 pin male header


USBJP123.small.JPG DG-JP12-02_small.jpg DG-JP1-U02_small.jpg DG-JP1-P02_small.jpg ext_small.jpg pl2303.small.JPG

Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com



10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!