Build a simple JP1 cable

From TIAO's Wiki
Revision as of 12:23, 27 September 2009 by Admin (talk | contribs) (→‎Let's make it)
Jump to: navigation, search

10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!

USBJP123.small.JPG DG-JP12-02_small.jpg DG-JP1-U02_small.jpg DG-JP1-P02_small.jpg ext_small.jpg pl2303.small.JPG

Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com


Parts List

  1. 4 feet of flat ribbon cable
  2. DB25 Housing with Grommet, scews and wire holders
  3. DB25 connector
  4. 1.0k resistor X 2 (necessary for Kameleon and other remotes)
  5. 1N5818 schottky diode works for both desktops and laptops
  6. 6 pin female IDC connector to fit your remote (with strain relief)
  7. 6 pin male header
Parts List

Let's make it

  1. Familiar with all the components.
    Parts
  2. Put some melted solder into the cup 2, 3, 4, 11, 18 and 25 of the DB25 male connector as shown in picture. imgfeed_015.jpg|none|thumb|

USBJP123.small.JPG DG-JP12-02_small.jpg DG-JP1-U02_small.jpg DG-JP1-P02_small.jpg ext_small.jpg pl2303.small.JPG

Buy Communication Cable for Universal Remote Controls from http://www.easymg.com or http://www.diygadget.com



10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
Retrieved from "http://www.tiaowiki.com/wiki/index.php?title=Build_a_simple_JP1_cable&oldid=634"