Program FPGA Using urJTAG
From TIAO's Wiki
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
How to program FPGA with TIAO USB Multi Protocol Adapter (TUMPA) Under UrJTAG
- Copy all BSDL files, for the devices that is in the current scan chain to a new folder d:/mybsdl
- Get into UrJTAG prompt by launch urjtag.exe or urjtag (in a DOS prompt window)
- Initialize TUMPA by issuing command: "cable ft2232 vid=0403 pid=8A98"
- Set BSDL path by issuing command: "bsdl path d:/bsdl"
- Detect the chain, issuing command: "detect"
- Program/Play the SVF file by issuing command: "svf d:/svf/file.svf progress stop" (this will show the progress, and stop on errors)
If you have encountered errors, try the following:
- Make sure the TUMPA is connected to the USB port.
- Make sure all the JTAG wires are connected correctly.
- Try to reduce the frequency by issuing command: "frequency 600000" or lower.
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
