Difference between revisions of "TIAO Xilinx XC2C64A CoolRunner-II CPLD Dev Board (Reset Glitch) Tutorial"
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!
(→Jumper Positions) |
(→Configuration for Slim) |
||
Line 35: | Line 35: | ||
[[Image:RGH-PINs.png|none]] | [[Image:RGH-PINs.png|none]] | ||
− | == | + | == Install it on slim == |
=== Jumper Positions === | === Jumper Positions === | ||
Line 54: | Line 54: | ||
+ | === Solder the wires === | ||
+ | |||
+ | First, you need to disassemble your slim. | ||
Revision as of 20:12, 26 October 2011
Contents
Buy various JTAG cables for your Satellite Receiver, Cable Modem, Wireless Router, Standard Wiggler from http://www.easymg.com and http://www.diygadget.com
Overview
In this tutorial, I am going to show you how to install TIAO Xilinx XC2C64A CoolRunner-II CPLD Dev Board (Reset Glitch) on your XBOX 360.
Required Hardware and Software
- TIAO Xilinx XC2C64A CoolRunner-II CPLD Dev Board (Reset Glitch)
- Soldering iron and solder
- Optional: XBOX 360 Case Opening Torx Tools
TIAO Xilinx CoolRunner-II Dev Board Overview
When we designed this board, we only had on goal in our mind: make it simple. Simple to install, simple to use. We achieved it. You don't need to solder any components, no jumper wires, it even provides a on-board 5v to 3.3v LDO (Low-drop Voltage Regulator) for JTAG programming. One board works for all.
Key features:
- Pre-populated required components for phat: 100nF Cap, 1K and 22K Resistors, three 1N4148 Diodes.
- Pre-populated required component for slim: 220pF cap. However, we also added two 3-30pF trimmer capacitors, thus the capacitance can be easily adjusted from 226pF to 280pF.
Pinout of the board:
Install it on slim
Jumper Positions
There are three jumpers on the dev board. You can move jumpers on different positions for slim or phat. The default configuration is for slim.
Here is the jumper positions if you want to install it on a slim:
Use a jumper to short P2.1 and P2.2 Use a jumper to short P2.3 and P2.4 Use a jumper to short P2.5 and P2.7 (optional)
Here is the photo (this is the default configuration):
Solder the wires
First, you need to disassemble your slim.
Buy various JTAG cables for your Satellite Receiver, Cable Modem, Wireless Router, Standard Wiggler from http://www.easymg.com and http://www.diygadget.com
10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!