ps2gamer wrote:
Hi all,
I made good progress through the purchase of a single cable "dlc5".
However I doubt that the problem mentioned in my first post from a crash of "CFE" because after doing a backup, the content is almost equal to the one I found on this forum.
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=622044#622044
To refocus my problem.
Since the update "TomatoUSB", my router "Linksys E4200" no longer works, even the network ports LEDs do not flash when the ignition to warn that they have been initialized, except I think c is the chipset that does this, not the "CFE" ?
The logo "CISCO" also remains fixed, then that should be flashing at the time of ignition "electric".
I of course tried a connection through the port "COM3" to access the interface "CFE", but nothing.
I even tried to re-flash the "CFE" with this backup, but nothing n'à change, and worse, "tjtag" remains blocked at this stage :
tjtag3.exe -backup:cfe /cable:dlc5 /port:BE00 /byte_mode /fc:158
================================================
EJTAG Debrick Utility v3.0.2.1 Tornado-MOD
================================================
Selected port = 0xBE00
Detected IR chain length = 32
Number of device(s) = 1
IDCODE for device 1 is 0x1471617F
Idcode 0x1471617f IR Length 32
Jtag is in LV mode
switching to MIPS mode 1
Probing bus ... Done
Instruction Length set to 5
CPU Chip ID: 00000000000010001100000101111111 (0008C17F)
*** Found a Broadcom BCM4716 Rev 1 CPU in MIPS MODE chip ***
- EJTAG IMPCODE ....... : 01100000010000010100000000000000 (60414000)
- EJTAG Version ....... : 3.1
- EJTAG DMA Support ... : No
- EJTAG Implementation flags: R4k ASID_8 MIPS16 NoDMA MIPS32
Intial value of Control register is 000000CC
Intial value of status register is 0000007F
01111111 (0000007F)
Status bit 7 Busy Inverted pin 11 = 1
Status bit 6 *Ack pin 10 = 1
Status bit 5 Paper-out pin 12 = 1
Status bit 4 Select pin 13 = 1
Status bit 3 *Error pin 15 = 1
* means low = true, e.g., *Error
VCC connected
values of Control register after init 0x000000CC
value of status register after init 0x0000007F
system reset complete
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ... Skipped
Halting Processor ... <Processor Entered Debug Mode!> ... Done
Init PrAcc ... Done
Clearing Watchdog ... Done
I feel that it is completely broken, and that I should buy another.
Thank you !