Difference between revisions of "TIAO USB Multi Protocol Adapter User's Manual"

10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!

Revision as of 15:12, 9 August 2011

Overview

The TIAO USB Multi Protocol Adapter (TUMPA) is a multi-functional USB communication adapter for hobbyists or engineers. The adapter is based on FDTI's flagship communication chip FT2232H, a USB 2.0 Hi-Speed (480Mb/s) to UART/FIFO IC. It has two multi-protocol synchronous serial engines (MPSSEs) which allow for communication using JTAG, I2C and SPI on two channels simultaneously.

Technical Specifications

• USB 2.0 Hi-Speed (480Mb/s)
• JTAG / IEEE 1149.1 compatible.
• JTAG Baudrate up to 30Mbits/sec (programmable)
• On board voltage translation via 74LVC14T245 (can be enabled / disabled via software or jumper)
• JTAG signals are 5V to 1.8V tolerant
• ARM Muli-ICE 20-pin header compatible.
• Separate SPI/I2C/Serial interfaces
• Configurable output of RS232 (MAX3243) or TTL level for serial communication
• Configurable auto power down for MAX3243
• Target board can be powered by TUMPA (3.3V) or self powered (via jumper)
• 4 on-board LEDs / PWR, Targt PWR, TX and RX
• 1 2x10 20 PIN JTAG header
• 1 2x5 10 PIN RS232 level 2.54mm IDC header
• 1 2x5 10 PIN TTL level 2.54mm IDC header
• 2 2x3 6 PIN SPI 2.54mm IDC header
• 1 x DB9 connector (male, RS232 level)
• Target board power jumper
• Buffer chip enable jumper
• RS232 chip auto power down jumper
• RS232 or TTL output jumber
• USB Hot-Plug / JTAG Hot-Plug.
• USB over-current protection via on-board resetable fuse.
• Strong ESD protection on USB signals.
• Based on the FTDI FT2232H USB device.
• Designed for FTDI MPSSE easy-to-use.
• Free drivers for Linux.
• Free drivers for Windows XP, Windows Vista and Windows 7
• Support both 32 bit and 64 bit operating systems
• Board dimension: 65.41mm X 58.55mm (2.58" X 2.31")

Board Layout

1. DB9 male RS232 connector

10 PCS, 10cm x 10cm, 2 layers prototype for $38.80 shipped!