View source for Mini Portable 150Mbps Wi-Fi Wireless AP/Client/Router/Bridge/Repeater FW150RM Client Mode Instruction

<meta name="keywords" content="TIAOWIKI,Smart sprinkler controller, raspberry pi, wifi, network, PCB, Prototype, Cheap, fast, schematic, protel, altium, eagle, expressPCB, JTAG,TJTAG,FTA,JTAG,WRT54G,DD-WRT,debrick,tomato,router,wireless router,motorola modem,sb5100,wiggler,arm,mips,avr,buffered jtag,unbuffered jtag,10 pin,20 pin, 12 pin,xbox,xbox 360,modchip mod-chip,mod chip,liteon,lite-on,samsung,hitachi,lg,dvd rom,sata,dvd key,usb probe,cable modem, usb spear,serial spear, serial probe, extract dvd key,mod xbox 360,video games"></meta>
<meta name="description" content="TIAO Smart Sprinkler"></meta>

== How to setup FM150RM to client mode ==

FM150RM is a portable Wireless AP/Client/Router/Bridge/Repeater.  In this tutorial, we are going to setup it up to work in client mode, which allows a wired device to be connected to a wifi network.  For example, the TIAO Smart Sprinkler does not support wifi, however it does support wired network.  You can use FM150RM (in client) mode to connect TIAO Smart Sprinkler to the internet.

=== Check the existing Wifi information ===

In order to connect to an existing wifi network, we need the following information of the existing wifi system:

* SSID
* Router's MAC address
* Wifi password

For MAC address of the router, you can check your router's configuration page, or on Windows machines, run command '''netsh wlan show networks mode=bssid''', the bssid is the MAC address of the router.


=== Setup the FW150RM to client mode ===

First we need to connect the FW150RM to a PC or laptop to make the changes.  Now power on FW150RM, and then connect the FW150RM to a PC using a network cable.  Then change the PC's IPV4 address to be manual as below:

[[Image:Ipv4props.jpg||none]]


then open a browser window, change the address bar to http://192.168.1.253

You will be prompted for an user name and password.  Both username and password are admin.

After you logged in, you will be presented with this screen:

[[image:setupwizard1.png||none]]

Click next to continue.

[[Image:setupwizard2.png||none]]

Select the check box at the top (allow software to control the mode) and select Client as shown in the picture above, then click next.

Then click Scan button:

[[image:setupwizard3.png||none]]

Find the wifi network you'd like to join, then click the connect link:

[[Image:setupwizard4.png||none]]

Fill in the wifi password and click next:

[[Image:setupwizard5.jpg||none]]

Then click reboot button to reboot the FW150RM.

[[image:setupwizard6.png|none]]

Now wait for the progress bar to reach 100%.  Then the page should auto refresh.  Now your FW150RM is configured working in Client mode.

If it does work at first try, reset the FW150RM by hold the reset button on the FW150RM for 20 seconds, wait for LED flash 5 times, then repeat the above steps.